Slow infill printing.

Hi,
Somehow I've managed to configure things to print the infill really slow. I don't understand why.

I've configured outer shell and first layer to go slower than normal, but especially the first layer is quite quick, so I'm thinking the infill should be at least as quick as that. But it is going really slow.

Does anybody know what I might have configured to make this happen?

My printer is an Anet A6.

What software are you using and could you show a screenshot of your infill settings?

Edited 1 time(s). Last edit at 12/18/2019 04:42PM by Ohmarinus.

---

http://www.marinusdebeer.nl/

I seem to be using Slic3r 1.3.0-dev. (help->about). Attached is the screenshot. Thanks for looking at it. :-)

I see that you see "infill 100%", This is what I use for the object that I noticed this "some layers slow" on. The object that you see in openscad in the other window should've been printed with 30% infill and then it wouldn't have run out of filament and my printer wouldn't have been stuck now.

Edited 2 time(s). Last edit at 12/19/2019 06:55AM by rew.

check the infill speed in speed settings

I don't see anything hinting at this behaviour there either.

You have infil speed set to auto atm,try setting it to something like 60mm/s, maybe auto is slowing it down for some unknown reason.

OK. Thanks. I'll try it once I get my printer back up-and-running.