PrusaSlicer - Slic3r

Have setup PrusaSlicer - Slic3r quite some time ago, well today I am printing the first Model.

Completing the 4 Printed Marvel mask Ear relief supports with PrusaSlicer - Slic3r 2.3.0.
I see that other than the print speed configurations in my PrusaSlicer - Slic3r configuration they successfully printed correctly.

I will go threw the configurations again to see where I miss configured the Print Speeds and Support angles.

---

Computer Programmer / Electronics Technician

How do I Turn off the first raft layer under supports?
Can any one help me remove this unneeded Raft.

Information I found.

No.
It is not possible to remove it with the current versions of Prusa Slicer (as of 2.2.0).
Doing so results in a much greater risk of support failure.

---

Computer Programmer / Electronics Technician