Currently,
my garage is to cold to have Repetier Host start my heatbed.
It is probably somewhere around zero centigrade, but the bed temperature states -3
The heatbed icon disapprears immediately after connecting.
When I pre-heat the bed a few degrees with a hair drier, it will come-up and i can toggle it to heat.
After that all's fine.
I see no specific positive in this.
Is it a parameter ? Can I bypas that ?
Thomas
www.3daybreaker.blogspot.com
Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)