Repetier-Host V2.0.5, Slic3r not sure what's going on?
Posted by kd6hq
|
Repetier-Host V2.0.5, Slic3r not sure what's going on? February 24, 2018 02:46PM |
I went to do a thin wall test today and got a surprising result.
First I drew a box 20mm sq. box with 0.40mm walls.
Then I ran it thru Slic3r and got this?
I don't know where the cut on the wall came from or why it is misaligned.
Any one run into this before?
thanks
First I drew a box 20mm sq. box with 0.40mm walls.
Then I ran it thru Slic3r and got this?
I don't know where the cut on the wall came from or why it is misaligned.
Any one run into this before?
thanks
Sorry, only registered users may post in this forum.