Welcome! Log In Create A New Profile

Advanced

Scaling

Posted by DanielG 
Forum List Message List New Topic
DanielG
Scaling
February 10, 2013 11:42PM
If a part is done in inches whats the approximate correct scale? Right now the part is tiny... I dont hae the ability to change the part to mm... I did this before but for the life of cannot find ref to it again! any help?
Reply Quote
DanielG
Re: Scaling
February 10, 2013 11:52PM
NM my part was wacked...25.4 on a good stl works fine thought i was goin crazy
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login