Welcome! Log In Create A New Profile


Megatronics v2 and Z

Posted by HegerTechnik 
Megatronics v2 and Z
October 19, 2013 02:26PM
i have the Megatronics Board v2. After little changes in pin.h (Heatbed was wrong pin) Thermocoupler was wrong Pin) all works, but Z dont Move.

With Marlin works great. So i have load Repetier Firmware without EEprom to Erase the settings. Nothing. Z dont Move.
pin.h are the same pins in Marlin Firmware.

What must i change? All other things now ok. My last Problem to Print something...

Megatronics v2
prusa i3

Edit: After click on the Z Button i hear one click of the motors... Something in Config was wrong

Edited 2 time(s). Last edit at 10/19/2013 02:54PM by HegerTechnik.
open | download - Configuration.h (47.3 KB)
open | download - pins.h (41.3 KB)
Re: Megatronics v2 and Z
October 20, 2013 05:46AM
Assuming your PINS.H i ok, you have both Z_min and Z_max Hardware endstops set. Repetier may get confused.
Try enabling just the one you really want to use when homing.


no toys here...sorry
Re: Megatronics v2 and Z
October 20, 2013 06:05AM
I Check this. Thanks
Sorry, only registered users may post in this forum.

Click here to login