Welcome! Log In Create A New Profile

RepRapPro Mono Mendel with Repetier-Host?

Posted by Repdav

Repdav

RepRapPro Mono Mendel with Repetier-Host?
November 11, 2013 04:47PM

Registered: 11 years ago
Posts: 7

Hi all..

Wondering if anyone has used any RepRapPro machine using Repetier-Host software, as when I connect it seems connected but nothing happens.

If I need to upload Repetier-Firmware on the Melzi board it says for Huxley but it does not mention the Mono Mendel.

Has anyone tried this configuration?

Reply Quote

.xack.

Re: RepRapPro Mono Mendel with Repetier-Host?
November 13, 2013 05:41PM

Registered: 11 years ago
Posts: 56

hallo,

first of all, witch os are you using? Mac, Windows, Linux?
I have a ReprepPro Mono Mendel with standert marlin firmware.
It works with reptier host on Windows and Mac OS X Maveriks without any problems.
Make sure you set the baud rate in the repetier printer settings to 115200

Reply Quote

Repdav

Re: RepRapPro Mono Mendel with Repetier-Host?
November 16, 2013 09:27AM

Registered: 11 years ago
Posts: 7

Hi xack,

Thanks for your reply..

I am using Win7 64 bits.

The marlin firmware is the one shipped with the RepRapPro Mono Mendel? I mean the RepRapPro Marlin firmware?

Or you mean the standard Marlin is another I should upload to the Melzi conroler.?

Thanks for sharing this experience Xack.

Reply Quote

rafaellsi

Re: RepRapPro Mono Mendel with Repetier-Host?
November 18, 2013 06:54PM

Registered: 11 years ago
Posts: 2

I just set correct "Port" and "Baud rate = 115200" (Config -> Printer settings).It is working on my printer with original RepRapPro Mono Mendel firmware.

Reply Quote

Repdav

Re: RepRapPro Mono Mendel with Repetier-Host?
November 21, 2013 01:35PM

Registered: 11 years ago
Posts: 7

Hi Rafaellsi,

Thank you but,
I have tried those settings.. as I know the baud rate has to be 115200 plus the correct port. sad smiley

not sure what could be happening.. as also my brother has another RepRapPro Mendel and we still can not use Repetier-Host

Reply Quote

repetier

Re: RepRapPro Mono Mendel with Repetier-Host?
November 22, 2013 02:52AM

Registered: 13 years ago
Posts: 2,705

Make sure protocol is not binary, mendel does not support this. What do you see in the log window at the bottom when you connect?

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

Reply Quote

Repdav

Re: RepRapPro Mono Mendel with Repetier-Host?
November 22, 2013 02:12PM

Registered: 11 years ago
Posts: 7

Hi,

It connects but does not do anything.

Log window does not capture anything also.

But the botton status bar says

Connected:default Extruder:0.00C command waiting, if I send e.g M555 or M503 the command waiting increase.

Thank you