Welcome! Log In Create A New Profile


host 0.95f crashing

Posted by adambrum 
Re: host 0.95f crashing
June 29, 2014 05:43PM
I think the driver runs out of memory. You should not underestimate the ram requirements for large files.

Totally agree! Thanks for the tip on Simple visualization- I forgot that was available. For anyone else looking for it, the menu chain is: Config>3D View Configuration>Filament>Filament Visualization
Re: host 0.95f crashing
July 22, 2014 08:03PM
just found this thread.
Read through it, installed .net Framework 4.5.2 and now even detailled Models load in seconds!

thanks for the advice, repetier!

I guess tomorrow my printer will run almost non-stop^^

Sorry, only registered users may post in this forum.

Click here to login