Welcome! Log In Create A New Profile


Repetier hoost speed controllers

Posted by Replace 
Repetier hoost speed controllers
October 12, 2014 12:33PM
I am switching from Pronterface to Repetier Host.
Now ì notice that there are 2 speed controllers that can be adjusted during print.

One for movement and one for flow.
Are they connected ? If I upgrade speed, will flow also increase ? Or is it ment to be opposite ?


Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)
Re: Repetier hoost speed controllers
October 13, 2014 03:39AM
Speed is speed. There is no need to change flow if you change speed. Normal flow is mm^3/printed mm and is not influenced by flow. Use flow only to change the amount of filament e.g. if you get too much filament you can reduce it there. But normally your slicer should produce the right amount so flow is normally not needed.

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!
Sorry, only registered users may post in this forum.

Click here to login