"z probe out bed" message July 03, 2015 04:45PM |
Registered: 9 years ago Posts: 223 |
Re: "z probe out bed" message July 04, 2015 03:04AM |
Registered: 12 years ago Posts: 2,705 |
Re: "z probe out bed" message July 04, 2015 05:56AM |
Registered: 9 years ago Posts: 223 |
Quote
repetier
What I do not understand is "Z probe out bed" because the firmware does not have this error message. Is this really what you get or did you change the message? Or did you get this with Marlin?
Homing does not do any z probing stuff, so you should never get a z probe message while homing. G30 could do but that is not z homing.
I also think you ruled firmwares as M211 is not implemented in Repetier. In repetier you simply open EEPROM editor to see all settings including length, z probing points etc.
Re: "z probe out bed" message July 04, 2015 08:23AM |
Registered: 12 years ago Posts: 2,705 |
Re: "z probe out bed" message [Resolved] July 04, 2015 02:57PM |
Registered: 9 years ago Posts: 223 |
Re: "z probe out bed" message July 13, 2016 01:05PM |
Registered: 8 years ago Posts: 61 |