Hello,

I was interested in adding support for the AD597 thermocouple.
To do this I need to know where to define it in the Repetier firmware files.
Also, i need to know the format that is used.

Any help would be appreciated, Thank you.

Isn't the output the same as for AD595 = 10mv/°C? Then all you need is set temp. sensor to 100. Otherwise check AD595 implementation in Extruder.cpp -> updateCurrentTemperature to see how to change to other formula.

---

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!

I see, after matching up the datasheets of both the AD595 and AD597, ironically,
it would seem that the AD597 will report a more accurate temp than the 595 using your coding implementation.

I guess a new implementation for the 597 is not needed.

Due to the fact the AD597 will work well within the temperatures we are concerned about, I would recommend appending the the 597 selection
to your code and firmware configuration application.

AD595 Datasheet
AD597 Datasheet

Thank you for your help.