A problem found with 1.5.4 August 12, 2015 09:01AM |
Registered: 9 years ago Posts: 17 |
Re: A problem found with 1.5.4 August 15, 2015 04:09AM |
Registered: 12 years ago Posts: 2,705 |
Re: A problem found with 1.5.4 August 15, 2015 05:18AM |
Registered: 10 years ago Posts: 739 |
Re: A problem found with 1.5.4 August 25, 2015 07:00AM |
Registered: 9 years ago Posts: 17 |
I use Curaengine too. Maybe you can update to 1.0.6, it's ok, but for unknown reason1.5.4 is not working well.Quote
maralb
I also have problems on prints near the hole
but I think it is the fault of slicer
be a difficult problem to understand
use delta printer Repetier 0.92.3
Sliced CuraEngine
[attachment 60027 1.jpg]
[attachment 60028 2.jpg]
Re: A problem found with 1.5.4 August 25, 2015 08:57AM |
Registered: 12 years ago Posts: 2,705 |