This is probably a simple question but the Repetier configuration.h file is still mostly gibberish to me. Lol.
I've leveled the print bed and when I home the z-axis it's at just the right height above the print bed. However, when I print the first layer, the extruder nozzle rises slightly off the bed surface (maybe 1mm or less). This is causing some prints to detach from the bed surface during printing.
At first I thought it was a setting in Cura so I tried Slic3r and had the same exact results. This is what makes me think it's a setting in the firmware.
Any advice?
My printer: He3D XI3 (http://reprap.org/wiki/XI3)