I'm setting my Filament first layer and other layers to 215 ND 195 (for PLA) but when I start the print job, the Manual Control tab shows the filament default settings of first layer 235 and other at 200.
when you change a setting you need to click save and when you do a box pops up to save as that name or give it a new name like PLAorange. if you gave it a new name when you saved it then once you exit config before you slice male sure that name appears in the list below the slice button this must be done before you slice and print. If you again change your temp it must be saved and you have to re slice again
