Currently,
my garage is to cold to have Repetier Host start my heatbed.
It is probably somewhere around zero centigrade, but the bed temperature states -3

The heatbed icon disapprears immediately after connecting.

When I pre-heat the bed a few degrees with a hair drier, it will come-up and i can toggle it to heat.

After that all's fine.
I see no specific positive in this.

Is it a parameter ? Can I bypas that ?

Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

There is a minimum temp setting in the firmware, normally this is used to detect a disconected thermistor

So, if I set this to minus 10,
It will startup ?

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

Quote
Replace
So, if I set this to minus 10,
It will startup ?

yep that should work