Hi all,
I've just set up my new 3D printer (
helloBEEprusa Serial 1111500275-to-X). The machine works fine itself, but I am finding it impossible to connect it with
Repetier-Host software.
The firmware of the printer is
Marlin 1.1.0-RC3.
So my question is, is Repetier Host compatible with this firmware? The program shows this error message: "Unknown printer firmware".
Is there anything I can do to make it compatible?
I am using a
MAC !
I need Repetier Host since it has manual control.
Thank you very much, any help will be appreciated!