Is there a Gcode command or setting in EEPROM to remove the saved mesh?

I would like to switch back to manual leveling while I wait for a new probe, without having to flash a new firmware without auto leveling.

Edited 1 time(s). Last edit at 01/05/2020 02:35PM by peps1.

G33: Measure/List/Adjust Distortion Matrix (Repetier - Redeem)

Usage
G33
G33 Lnnn
G33 Rnnn
G33 Xnnn Ynnn Znnn
Parameters
L0 List distortion matrix in a report
R0 Reset distortion matrix
X[pos] Y[pos] Z[zCorrection] Set correction for nearest point