I am printing with repeater Host.

After the last upgrade of it, the motors keep engaged after movements.

It used to work like this: In manual control I home the extruder. After that I can still move the carriage or the plate.

Now after homing, all motors keep their position and I can not move either.

Is there a setting that has been reset ? Can I change this back ?

Thomas

---

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)

there is a setting in Marlin, but I don't know about anything else