Welcome! Log In Create A New Profile

Advanced

Problem axis prusa i3

Posted by alfombra 
Problem axis prusa i3
August 27, 2016 08:41AM
hello i just introduced my self and hope you can resolve my problem.
the thing is that i assembled a prusa i3 by myself and the problem comes with the movement of the axis. I use the pronterface to test the movement but every time i send a command to move any axe the motor move a couple of times where i want but then it stops and makes strange noises and after a couple of seconds i can move them again. I use nema I7 steppers with drv8825 drivers and ramps 1.4 if can help.
Hope we can reach a solution. thanks for reading
Sorry, only registered users may post in this forum.

Click here to login