buZz's Tantillus build - Metric
Posted by buZztiaan
|
buZz's Tantillus build - Metric June 24, 2012 12:36PM |
Might as well just start a topic to gather stuff for my build 
Printing the case now from cheapass yellow chinese filament ( 20 euro a kilo )
I will be sourcing all metric parts, as Sublime suggested. He is going to remodel two parts (i think?) towards metric, and i will be sourcing some 8mm rods with tolerances to fit inside a 608 bearing, which should be all thats needed...
Picture included
Printing the case now from cheapass yellow chinese filament ( 20 euro a kilo )
I will be sourcing all metric parts, as Sublime suggested. He is going to remodel two parts (i think?) towards metric, and i will be sourcing some 8mm rods with tolerances to fit inside a 608 bearing, which should be all thats needed...
Picture included
|
Re: buZz's Tantillus build - Metric June 24, 2012 12:39PM |
Oh yeah, I'm also streaming most of the printing on [bambuser.com] so I can walk away and see when done to go and start a new part 
|
Re: buZz's Tantillus build - Metric June 26, 2012 03:19AM |
The smallness is one of my main motivations for building it
I need a printer to carry along camping this summer (and maybe next one) to nerdevents, probably on bike
I need a printer to carry along camping this summer (and maybe next one) to nerdevents, probably on bike
|
Re: buZz's Tantillus build - Metric July 05, 2012 03:01PM |
Thanks a lot
Now to get arcol to do my bidding
Now to get arcol to do my bidding
Sorry, only registered users may post in this forum.