Tantillus Plus files?

Are these out in the public somewhere?

I don't have any files for the plus. Two other people are working on them and when they see this they may post what they have so far. I actually had a drive fail a month ago and lost everything new I had been working on. I lost the new firmware, machine upgrades, slicing profile, etc.

---

FFF Settings Calculator	Gcode post processors	Geometric Object Deposition Tool Blog
Tantillus.org	Mini Printable Lathe	How NOT to install a Pololu driver

I have some models made up for a 100mm x 200mm x 100mm build area Tantillus if you want them. They are based on some of the the old Metric Tantillus models from WWFP and may have some minor dimensional issues that have since arisen. I should fix them up anyways though, so if you want to build it I can take the time to fix them up and send them your way. I don't know who else is working on a bigger version, but their files might be better than what I have.

Eric Young Wrote:
-------------------------------------------------------
> I don't know who else is
> working on a bigger version, but their files might
> be better than what I have.

That would be me...

I'm working on a 150 x 150 x 200 version. It's currently on hold while we get the laser cutter installed and setup so that we can cut the acrylic. Once I have the panels assembled and make sure there are no major problems, then I'll share the files.

---

----------------
Lem Fugitt
3D Printing Dreams
Robots Dreams
"The map is not the territory."

yay! looking forward to it.

Robots-Dreams Wrote:
-------------------------------------------------------
> Eric Young Wrote:
> --------------------------------------------------
> -----
> > I don't know who else is
> > working on a bigger version, but their files
> might
> > be better than what I have.
>
> That would be me...
>
> I'm working on a 150 x 150 x 200 version. It's
> currently on hold while we get the laser cutter
> installed and setup so that we can cut the
> acrylic. Once I have the panels assembled and make
> sure there are no major problems, then I'll share
> the files.

Have you made any progress? Are you in a position to release the files?

thanks,
Brendin

Still waiting on the laser cutter installation/setup to cut the panels.

---

----------------
Lem Fugitt
3D Printing Dreams
Robots Dreams
"The map is not the territory."

I Have files (corel) for 3mm dibond version with 150x200x150 table. I've redesigned extruder(it have now 1:9 ratio) Z upper and lower rods holders and corners and many files nothing left orginal, soon I will give it public ehen i'm test it. But I can now give the sides drawings