Welcome! Log In Create A New Profile

Printing Tantillus extruder

Posted by Robonz

Robonz

Printing Tantillus extruder
January 23, 2014 04:55AM

Registered: 10 years ago
Posts: 87

I have not printed the extruder drive body before and am going to do it tomorrow. Before I do, any tips on the kisslicer settings. Looks like I will need to turn on support which I have not done before and I guess it will need more than 25% infill that I normally do.

Most specifically on the support tab what settings should I choose?

Cheers

Reply Quote

flemming

Re: Printing Tantillus extruder
January 23, 2014 10:05AM

Registered: 10 years ago
Posts: 21

I too would be interested in some kisslicer guidance for printing Tantillus replacement parts. Now that I'm finally up and running I figure that spare parts should be on my shortlist of things to print in the near future. I'd love to know if there were specific changes made for individual parts or if most parts were printed with a common config and if so what that was.

Robert

Reply Quote

Sublime

Re: Printing Tantillus extruder
January 23, 2014 11:54AM

Registered: 13 years ago
Posts: 2,947

No support needed. I would print it with at least 2 perimeters and 25%+ infill. For a really strong part I would go with 40%+ infill.

FFF Settings Calculator	Gcode post processors	Geometric Object Deposition Tool Blog
Tantillus.org	Mini Printable Lathe	How NOT to install a Pololu driver