Hi everyone,
I'm currently working to provide a bit more cooling to the extruder motor and ramps board in my Tantillus and so I purchased a couple of small 12v fans, one of them 0.195A and the other 0.11A. I'm using a 15v 6A power supply suggested in the Tantillus BOM. I'd like to have these fans running all of the time so I was thinking about branching them directly off of incoming power but I'd like to hear your thoughts beforehand so I don't accidentally burn my house down

I'm sure you can infer properly from my question that I'm a novice when it comes to power and electronics. Thanks for your help!