Acrilic plate holder for J-head
June 11, 2014 09:06AM
Hallo!
can someone give me a pattern to crop acrilic plate for j-head?
I don't have it in .dxf of case!
I make it in plexiglass
Thanks anticipately!!
Re: Acrilic plate holder for J-head
June 11, 2014 10:20AM
Ifs here

[github.com] Files/Laser Cutting

All Panels 3mm.DXF

Cheers
Keith
Re: Acrilic plate holder for J-head
June 11, 2014 10:59AM
ok, thank you!!
I had a doubt!
I did cut the acrylic case
....goes well with a thickness of 6mm?
Re: Acrilic plate holder for J-head
June 11, 2014 11:06AM
6mm works great or 1/4" (~6.3mm) would work fine I expect, the only problems I had was the bearings were not a tight fit on one panel so I re cut it. If I did it again I would cut it undersize and the ream to exact size. I love laser cutting because it is so fast and I have one in my garage now.
Re: Acrilic plate holder for J-head
June 11, 2014 11:17AM
I have done laser cut panels 6 mm
should get these days and I hope that comes be fine!
also because it cost me 80 euro!
Sorry, only registered users may post in this forum.

Click here to login