Hi all,

After a few month with my Tantillus sleeping in its case, I decided to try using the new taulman bridge.
But after a few test prints, it seems I can't use my Tantillus at all : when the print start, the nozzle move from 0.0 to its correct beginning position and then zip right to the opposite corner, 10.10, extruding on the way.

The behavior occured from time to time before, but now it has occured 5 time on a row.
Does anyone also have this issue ?

is it a slicer issue? I had trouble one time where my printer did some weird every time i ran one set of gcode but when i went back and re-sliced the model it stopped the issue.