Quote
Did you update your underplate DXF for ebay.com/itm/3007393706… yet? There is note on reprap wiki about it.
Quote
I'm trying to figure out how hard it is to adapt your design to use a makergear or jhead hot end, which are available over here
Re: US build January 12, 2013 04:50PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 14, 2013 07:14PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 14, 2013 07:16PM |
Registered: 13 years ago Posts: 615 |
Re: US build January 14, 2013 07:20PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 15, 2013 05:45AM |
Registered: 13 years ago Posts: 615 |
Re: US build January 15, 2013 01:27PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 15, 2013 02:16PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 19, 2013 06:05AM |
Registered: 13 years ago Posts: 615 |
Re: US build January 19, 2013 02:00PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 19, 2013 07:26PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 19, 2013 07:33PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 19, 2013 08:08PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 19, 2013 11:40PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 20, 2013 06:34PM |
Registered: 13 years ago Posts: 615 |
Re: US build January 21, 2013 09:47AM |
Admin Registered: 12 years ago Posts: 2,569 |
Re: US build January 21, 2013 06:38PM |
Registered: 11 years ago Posts: 18 |
Re: US build January 25, 2013 04:16AM |
Registered: 13 years ago Posts: 615 |