Endstop holder
Posted by Emmanuel
|
Endstop holder August 31, 2013 03:58PM |
Several people were having some trouble with the Z-endstop (not always well glued, or prefering to use screws), and Xav83 came up with some ideas for a endstop-holder...
I tried a few thing too, and finally ended with that simple part that hold the endstop with a zip-tie, and could be used on any 20x20 aluminium extrusion
(I'll probably use this part in other machines)
about // liberapay // flickr // wiki // thingiverse - github
I tried a few thing too, and finally ended with that simple part that hold the endstop with a zip-tie, and could be used on any 20x20 aluminium extrusion
(I'll probably use this part in other machines)
about // liberapay // flickr // wiki // thingiverse - github
|
Re: Endstop holder September 08, 2013 01:07PM |
going to implement it in the next prototype
Sorry, only registered users may post in this forum.