X & Y axis problems

Hi!!

finally y wired everything and uploaded the Marlin Foldarap2 Minitronic firmware.

Everything seemed to be ok till y moved X axis and Y axis backwards: both motors got blocked... I mean: if i move along X axis it goes well in one direction but when i try to move the motor backward it gets blocked, a really strange noise begins and the temperature of the nema increases a lot!!

The same happens to Y axis....

Both motors seem not to stop... i have to stop them via Repetier Host, Pronterface...


Someone with the same issue??

Edited 1 time(s). Last edit at 05/03/2014 12:59PM by nachetz.

Do you verify voltage on minitronics ?

And how do you connect endstop ?

I connected endstops as Emmanuel said on the recent endstops update...

I did not verify voltage... Z axis works perfect, and X & Y in one direction...

You were right!! too much voltage on X&Y....

i think its solved!

Quote
al44
Do you verify voltage on minitronics ?

And how do you connect endstop ?