Welcome! Log In Create A New Profile


Z Endstop Adjustment Bolt

Posted by jamesmoe 
Z Endstop Adjustment Bolt
March 15, 2015 11:25AM
When I first printed the foldarap there was no Z endstop adjustment bolt. I reprinted my Z sliders due to some play causing z wobble and want to make use of the z adjustment. How exactly does the adjustment bolt go together? I see no captive nut trap or anything else to hold the nut so the bolt can adjust up and down.


- jim
Re: Z Endstop Adjustment Bolt
March 31, 2015 04:07AM
In fact the bolt is screwed in the plastic, either by the top (it allow an easier adjustement on the fly), or by the bottom (it may be easier to screw it in if the z-slider is already on the foldarap)
Sorry, only registered users may post in this forum.

Click here to login