Bed leveling

Hi,

yesterday I did a little maintenance. Among others I checked the bed leveling with my dial gauge. Unfortunately the firmware did not cooperate with me. To mount the dial gauge I dismounted the extruder, unplugged it and tried to move the axis - but nothing than error messages appeared.

Is there any command to tell the firmware to ignore the temperature?

---

MfG / Regards

Stefan

---

Blog / Gallery / Wiki / Mendel90 kit since Sep 2013 from Nophead / Original Prusa I3 MK3 since Feb 2018 /
OpenScad Workshop: Kursdateien
Octoprint Patron since April 2016

I don't think so. I leave it plugged in.

---

[www.hydraraptor.blogspot.com]

How about obtaining a 15-way D type connector and soldering a 110k resistor to the thermistor pins. This can then replace the extruder assembly and fool the firmware.

Regards,
Neil Darlow

---

I try to write with consideration for all nationalities. Please let me know if something is unclear.
Printing with Mendel90 from fedora 25 using Cura, FreeCAD, MeshLab, OpenSCAD, Skeinforge and Slic3r tools.

But isn't is easier just to remove the extruder, place it down to the left of the M90 and then plug it back into the existing D connector?

Alan