Welcome! Log In Create A New Profile

Is There a Ground for Limit Switches?

Garry Bartsch

Is There a Ground for Limit Switches?
November 02, 2013 04:31PM

Registered: 10 years ago
Posts: 363

I suppose there is no ground for the limit switches but page 64 of the manual shows Ribbon 1 (red) as signal and Ribbon 2 as ground. This makes me wonder if there is some way to check for ground on the other switches? I don't think so but I don't know for sure so am asking just in case ... paranoia induced by ignorance. Slowly being cured by these forum members.

Thanks a lot.

Reply Quote

neildarlow

Re: Is There a Ground for Limit Switches?
November 02, 2013 05:40PM

Registered: 10 years ago
Posts: 541

There is no polarity requirement associated with the limit switches.

Regards,
Neil Darlow

I try to write with consideration for all nationalities. Please let me know if something is unclear.
Printing with Mendel90 from fedora 25 using Cura, FreeCAD, MeshLab, OpenSCAD, Skeinforge and Slic3r tools.

Reply Quote

Garry Bartsch

Re: Is There a Ground for Limit Switches?
November 02, 2013 06:13PM

Registered: 10 years ago
Posts: 363

Thank you Neil for this further antidote to ignorance smiling smiley