Hi !
I own a Mendel90 from Nophead may 2014.
The USB connector has been crashed and the repair was unsuccesfull.
I ordered a card "Melzi 1284p 3D Printer PCB - ATMEGA1284P with Heatsinks - RepRap, Mendel, Prusa" from wedo3dprinting.
Flashed with firmware from Nopheads github. Success
Open pronterface,
Endstops OK. (M119)
X motor - Debug communication OK, motor not moving
Y motor - Debug communication OK, motor not moving
Z motor - OK
Ext motor not tested
SD card - not connecting
Temp OK
Heatbed OK
What can i Do to troubleshoot ?
Is the card broken ?
Best regards
Henrik