Hi everyone,
I am building a Mendel 90 at the moment to go next to my other printers. I have had this kit for a while but finally got around to doing it
I have a Creality 4.2.7 Silent stepper board here from my Ender3 I was thinking about using
The original Mendel90 from Nophead was 12v but I would like to go 24v For heating times
The Creality board has everything I need on it but I have a quick question about the limit stops. The board only has X- Y- and Z- where as the Mednel90 uses Z+. Is this still usable with something like Neil's updated marlin? Is it something simple to change?
If this board is not suitable I do have a complete Ramps 1.4 setup here that I can use which I know will work so just after recomendations so I can choose which direction to go as I have to order the correct ends