Picture in the manual of Melzi wiring

Hi folks,

I was doing a last check-up on the wiring of the melzi before calling it a day and noticed that in the table in the manual it says the black wire (Bed thermistor GND) goes to the BTEMP GND terminal on the Melzi. But in the picture I see the red wire connected to that terminal. At least that is if the upper terminal of the two is BTEMP GND? Or am I seeing this the wrong way? I thought the table corresponds from top to bottom with the terminals from top to bottom on the melzi board.

Well spotted, but it doesn't matter because thermistors don't have a polarity. The OCD in me would keep black as GND as the manual says... ;-)

Ah thanks QP! That is sorted out then. As I'm quite bothered by OCD-ish behavior during these sort of projects myself, I'm gonna stick with black as GND as well

Edited 2 time(s). Last edit at 10/08/2013 06:36PM by Nilez.