Hi folks,
I've measured the resistance between the connections named in the manual. I have to mention I'm doing this with a cheapo multimeter but I'm getting 125KΩ for between the thermistor wires, instead of 100KΩ mentioned. Is this the multimeter, acting all unprofessional or is this ok? Also maybe these values are out of order?:
Extruder heater: 6,5Ω (manual: 5,8Ω)
Bed heater: 1,9Ω (manual: 1,2Ω)
Motors: around 2,5Ω (manual: 1,9Ω)