Mendel90 Kit ABS looks not good.
November 03, 2013 11:26AM
Hi

i have build the heatshield and clean the glass with alcohol or aceton.

the bed at 130 works fine.

the hotend have 230 degree but see the picture.

extrudine fine but something is wrong

z is calibrated just now

plz help me
Attachments:
open | download - tmp_PhotoGrid_1383495334698-745559534.jpg (477.4 KB)
Re: Mendel90 Kit ABS looks not good.
November 03, 2013 12:14PM
I'm no expert, but it looks like something is too hot? Have you tried bringing the nozzile temp down a bit? How warm is the room you are in?
Re: Mendel90 Kit ABS looks not good.
November 03, 2013 01:41PM
hi

i will try with cooler options

round about 20 degree because it is down stairs..

greetings smuk3d
Re: Mendel90 Kit ABS looks not good.
November 03, 2013 02:38PM
It is hard to tell from the photo as there is no scale but it looks like the upright bit is getting too hot. You could try increasing the minimum layer time or printing two at a time.

Something is wrong with the bottom layer as well. Perhaps too high.


[www.hydraraptor.blogspot.com]
Re: Mendel90 Kit ABS looks not good.
November 06, 2013 03:22PM
thanks..
it was the print speed for small layers ..
smuk3d
Sorry, only registered users may post in this forum.

Click here to login