Simplify3D Slicer April 04, 2014 10:19AM |
Registered: 11 years ago Posts: 77 |
Re: Simplify3D Slicer April 04, 2014 02:27PM |
Admin Registered: 17 years ago Posts: 7,879 |
Re: Simplify3D Slicer April 04, 2014 02:32PM |
Registered: 13 years ago Posts: 2,947 |
Quote
nophead
No I don't use anything that is not open source for Reprap.
FFF Settings Calculator | Gcode post processors | Geometric Object Deposition Tool Blog |
Tantillus.org | Mini Printable Lathe | How NOT to install a Pololu driver |
Re: Simplify3D Slicer April 04, 2014 04:44PM |
Admin Registered: 17 years ago Posts: 7,879 |
Re: Simplify3D Slicer April 05, 2014 02:49PM |
Registered: 10 years ago Posts: 22 |
Re: Simplify3D Slicer April 07, 2014 07:43PM |
Registered: 11 years ago Posts: 250 |
Re: Simplify3D Slicer May 06, 2014 11:50PM |
Registered: 11 years ago Posts: 76 |
Re: Simplify3D Slicer May 06, 2014 11:57PM |
Registered: 11 years ago Posts: 250 |
Quote
isolt
I got this response about licensing from them
"Your license allows you to install the software on up to 2 different machines that you own. For example, if you wanted to run it on a laptop and a desktop, that would be fine!"
So if you have a friend it looks a bit more affordable...
That manual support placement looks intriguing.
Re: Simplify3D Slicer May 07, 2014 12:13AM |
Registered: 11 years ago Posts: 76 |