Dot point cooling!
Posted by karabas
|
Dot point cooling! June 22, 2014 02:13PM |
I replaced my fan cooling with dot cooling ( how to say correctly?)
I bought:
- cheap china fishbowl air pump. I bought with 2 connectors 3L/min and regulator - 12$
- flexible tube
- alu tube (mine was TV antenna part)
- medical needle ( big diameter)
Test pyramid ABS, layer 0.3, high temp ( 230-250C). I did not clean glass from dust(did not print about a month) so some delamination
Edited 3 time(s). Last edit at 06/22/2014 06:35PM by karabas.
Sorry, only registered users may post in this forum.