Hello, I am doing the
print temperature calibration, but I can't find how to set the temperature of the hot end in the Skeinforge settings.
Anything I print using the PLA0.3 profile prints with an extruder temperature of 185, but under the Temperature tab in skeinforge, the base temperature is set at 200. The "Activate Temperature" button is not checked, so maybe it is not using those settings.
Where is the PLA0.3 profile getting the 185 degree temperature setting? I would like to change it. Thanks
EDIT: I see I can edit it in the gcode directly, but would be nice to know how skeinforge decides its 185
Edited 1 time(s). Last edit at 06/24/2014 06:35PM by Razorconcepts.