Printing support I notice "curling". See pic. But there is no delamination or overhangs so It's not real curling. I lowered down efeed (on the fly with M221 Sxx) as low as possible but it seems it's not feed problem. I think it something with speed changing. Acceleration?
What I need to tune to make all this flat?
When infill does not touch perimeters I see the same blobs...
It's PLA. Ramps1.4. Last Marlin.
Edited 2 time(s). Last edit at 07/03/2014 01:22PM by karabas.
