Wades extruder cracked
Posted by danlad1631
|
Wades extruder cracked April 11, 2015 11:23AM |
Registered: 11 years ago Posts: 180 |
My wades extruder has a lot of cracks in it and some are going all the way through in places, could this cause the filament to keep slipping? Where can I buy a new one?
I've tried adjusting the tension but it's made no difference. I've also tried printing with PLA and ABS and it slips on both.
I've tried adjusting the tension but it's made no difference. I've also tried printing with PLA and ABS and it slips on both.
|
Re: Wades extruder cracked April 11, 2015 02:27PM |
Registered: 10 years ago Posts: 439 |
Mine did that and I patched it together with epoxy then printed a new one.
My new one is printed using PETG and hasn't cracked.
[github.com]
Edited 1 time(s). Last edit at 04/11/2015 02:32PM by Ralph.Hilton.
My new one is printed using PETG and hasn't cracked.
[github.com]
Edited 1 time(s). Last edit at 04/11/2015 02:32PM by Ralph.Hilton.
|
Re: Wades extruder cracked April 11, 2015 03:59PM |
Registered: 11 years ago Posts: 541 |
Hi,
nophead's original parts glue well with Loctite SuperGlue. I repaired my cracked Wade's block in this manner and printed a replacement in ABS which is holding-up well so far.
Regards,
Neil Darlow
I try to write with consideration for all nationalities. Please let me know if something is unclear.
Printing with Mendel90 from fedora 25 using Cura, FreeCAD, MeshLab, OpenSCAD, Skeinforge and Slic3r tools.
nophead's original parts glue well with Loctite SuperGlue. I repaired my cracked Wade's block in this manner and printed a replacement in ABS which is holding-up well so far.
Regards,
Neil Darlow
I try to write with consideration for all nationalities. Please let me know if something is unclear.
Printing with Mendel90 from fedora 25 using Cura, FreeCAD, MeshLab, OpenSCAD, Skeinforge and Slic3r tools.
|
Re: Wades extruder cracked April 12, 2015 11:34AM |
Registered: 11 years ago Posts: 180 |
|
Re: Wades extruder cracked April 12, 2015 12:12PM |
Registered: 11 years ago Posts: 180 |
Sorry, only registered users may post in this forum.