Hi everyone,
I'm a brand newbie, after having just assembled the Mendel90.
I've printed a couple of things and now I'm experiencing a disconnect issue. I think I've narrowed it down to when I set the hotend or hotbed temperature via the buttons in Pronterface. This error is shown:
Setting hotend temperature to 220.000000 degrees Celsius.
Can't write to printer (disconnected?).
Clicking on the tickbox "Monitor Printer" will also cause the disconnect. But, if I connect to the printer whilst already having this ticked, it doesn't cause any issues, except the graph/monitoring doesn't seem to work properly. Moving around the x, y or z axis is no issue.
Any help or guidance would be greatly appreciated.
Thank you.
Nathan