The print starts fine then stops after the first few layers. I done a 5 hour print yesterday and it was fine.
I'm using Simplify3D and this is the message I get:
RECEIVED: echo:Marlin: 1.0.0 RC2
Marlin: 1.0.0 RC2
RECEIVED: echo: Last Updated: Sep 20 2014 19:47:56 | Author: nophead
Last Updated: Sep 20 2014 19:47:56 | Author: nophead
RECEIVED: echo: Free Memory: 12982 PlannerBufferBytes: 1232
Free Memory: 12982 PlannerBufferBytes: 1232
RECEIVED: echo:Using Default settings:
Using Default settings:
RECEIVED: echo
D card ok
RECEIVED: start
RECEIVED: echo:Marlin: 1.0.0 RC2
Marlin: 1.0.0 RC2
Any ideas?
Thanks