Hey All,
I'm trying to get ABS printing nicely on the Hackspace Mendel90, but am having layer adhesion problems.
I'm printing soap moulds:
But the outer layers are delaminating and the corners are lifting massively. I'm using slic3r at 50mm/s for everything, temperatures 230/115. Oddly, the inner surface (the actual mould) is fine, I dont get any cracking on it at all, so I'm guessing the cracks are coming from the right angle corners.
I tried building a heated chamber to stop any drafts:
But it diddn't help. Any thoughts? My next plan was to whack the temperature up to 240/130, but I'm not sure if that's too hot for RepRapSource ABS.
-Bob