Welcome! Log In Create A New Profile

Printing questions.

qianweikang

Printing questions.
January 21, 2015 08:28PM

Registered: 9 years ago
Posts: 13

Hi all,

I have printed a model by OM2. But it has a hole on the top now. How to fix it?

In addition, can I use 3dp pen to fix it?

QQ20150122092209.jpg

Regards,
Weikang

Edited 2 time(s). Last edit at 01/21/2015 08:56PM by qianweikang.

Reply Quote

danielis

Re: Printing questions.
April 01, 2015 03:51AM

Registered: 9 years ago
Posts: 64

It seem to me the coolingsettings are the cause for the hole.
There was not enough time for the material to cool down and get hard enough to carry the next layer.
I use 25s for PLA and 30s for ABS as the minimum time for one layer.
That means the printer will slow down once the time per layer is so small that he would finish it faster than the limits.