please give sugestion
September 06, 2015 12:44AM
hello, I using prusa i3 using pla material but in the down side of the product seem like rough or very coarse. is there any sugestion to make in the down side of the product become smooth? or is there something wrong in the parameters of bed temperature ?
Attachments:
open | download - DSC_5322.jpg (535.6 KB)
Re: please give sugestion
September 14, 2015 02:14AM
You need to post this in the printing section. This is the semi dead Magazine section.
Sorry, only registered users may post in this forum.

Click here to login