Hi Everyone!!
We are preparing for Kickstarter campaign with our 3D Printer and we need your support! This is our first 3d printer as a company and we want to create good first impression. We published our printing videos/photos on Instagram / Youtube / Reddit , you can check them with links at below.
Features ;
-CoreXY motion kinematics with cantilever bed design.
-Lighweight direct drive extruder with all metal volcano hotend
-Auto bed levelling with bltouch
-Flexible build plate with pei sheet
-Coloured touch screen with octodash GUI
-Klipper firmware
-İncluded Raspberry Pi
-Everythink will be open source after campaign succesfully done.
We will send our printers fully assembled and tested to every backers. Clay 1 will be avaible for 350 USD , follow our pre launch page to get notice when we launch!
Please follow us on Kickstarter Prelaunch page !!
[
www.kickstarter.com]
Instagram -
Youtube -
Reddit
We need your support for to bring this project to life. Please follow and share this project if you like!