Freaks3D the most portable 3D printer ever
Posted by KathyElecfreaks
|
Freaks3D the most portable 3D printer ever July 22, 2015 06:15AM |
ElecFreaks Tech has designed a 3D printer for Makers that is both portable and affordable.
A classroom desk. A living room floor. A meeting space. A coffee shop. An outdoor picnic table. These are just some of the places that were not well-suited for 3D printing until now. That’s because ElecFreaks Tech has unveiled a revolutionary FDM machine that is not only affordable but portable as well. Measuring 11.4” x 12.6” x 12.8” in size and weighing a little over six pounds, the Freaks3D will undoubtedly be welcomed with open arms by the DIY community.
Now live on Indiegogo, the Freaks3D boasts a design that will surely separate itself from a rather saturated market with an extremely small and lightweight frame that can be picked up by its customizable handle with only a finger or two. Due to low power consumption, the printer can run on a 12V battery pack, or a pair of 9000mAh lithium batteries for two hours if an outlet isn’t accessible.
Printer size: 11.4” x 12.6” x 12.8”
Build volume: 5″ x 6″ x 4″
Nozzle diameter: 0.4mm
Resolution: 100 microns
Connectivity: USB and SD card
Software: Cura, Repetier Host
Following in the footsteps of its latest crowdfunding success, the ELF VR drone, ElecFreaks Tech has already well surpassed Freaks3D’s initial goal of $20,000 on Indiegogo. Shipment slated for August 2015.
Refer to [igg.me] for more details.
A classroom desk. A living room floor. A meeting space. A coffee shop. An outdoor picnic table. These are just some of the places that were not well-suited for 3D printing until now. That’s because ElecFreaks Tech has unveiled a revolutionary FDM machine that is not only affordable but portable as well. Measuring 11.4” x 12.6” x 12.8” in size and weighing a little over six pounds, the Freaks3D will undoubtedly be welcomed with open arms by the DIY community.
Now live on Indiegogo, the Freaks3D boasts a design that will surely separate itself from a rather saturated market with an extremely small and lightweight frame that can be picked up by its customizable handle with only a finger or two. Due to low power consumption, the printer can run on a 12V battery pack, or a pair of 9000mAh lithium batteries for two hours if an outlet isn’t accessible.
Printer size: 11.4” x 12.6” x 12.8”
Build volume: 5″ x 6″ x 4″
Nozzle diameter: 0.4mm
Resolution: 100 microns
Connectivity: USB and SD card
Software: Cura, Repetier Host
Following in the footsteps of its latest crowdfunding success, the ELF VR drone, ElecFreaks Tech has already well surpassed Freaks3D’s initial goal of $20,000 on Indiegogo. Shipment slated for August 2015.
Refer to [igg.me] for more details.
Sorry, only registered users may post in this forum.