Phi: Open-source ESP32 3D Printer Controller with Built-In Wi-Fi and Ethernet
Posted by likha3d
|
Phi: Open-source ESP32 3D Printer Controller with Built-In Wi-Fi and Ethernet November 24, 2021 04:47PM |
Just launched a new controller board on Crowd Supply!
[www.crowdsupply.com]
Highlights about Phi:
1. Built-in Wi-Fi and Ethernet, use a web interface over the local network
2. Runs RepRapFirmware
3. Packed with hardware, lots of compatible modules
Please do check out the campaign page for more details.
Edited 3 time(s). Last edit at 11/24/2021 05:01PM by likha3d.
[www.crowdsupply.com]
Highlights about Phi:
1. Built-in Wi-Fi and Ethernet, use a web interface over the local network
2. Runs RepRapFirmware
3. Packed with hardware, lots of compatible modules
Please do check out the campaign page for more details.
Edited 3 time(s). Last edit at 11/24/2021 05:01PM by likha3d.
Sorry, only registered users may post in this forum.