My Z-Probe seemed to be working just fine, now it is giving me a reading of 75 instead of 950 as dictated by the documentation. Needless to say I don't know what to do because if I carry on regardless it just does not work.
When trying to run a print the hotend ends up nearly 2mm off the bed which obviously is a problem.
Any suggestions?
I have:
- Checked the polarity of the plug to make sure it is correct
- Re done the Axis compensation to make sure I'm not doing something wrong
- Made sure there is no incandescent lighting on that could affect the readings of the Z-probe
Edited 1 time(s). Last edit at 01/05/2014 09:06AM by gregstah.